This is the most difficult way to inflate your Full-Size Travelwedge, but we include it just in case you need it. Unwrap the foot pump; attach one of the white ends to the blue hose. Insert the white end into the clear flexible small valve. Make sure the black valve is completely closed. You may need to hold the white end so it does not pop off. With a continued effort this typically takes about 20 minutes to inflate. Once 95% inflated you can finish by blowing into the clear flexible valve to desired firmness.
Option 2: Common Hair Dryer on COOL Setting
In our opinion this is the quickest and easiest way to inflate your Full-Size Travelwedge. Start by making sure the clear flexible valve is closed. Next open the black valve and push you finger inside to open the flap. There is a small lock on the flap to keep it in the open position. Set your hair dryer to LOW and COOL (if you try this with hot air you will void your warranty as it can melt the pvc). With one hand, hold the outside of the black valve. With the other hand hold the hair dryer. Direct the COOL air from the hair dryer into the opening on the black valve. This typically inflates in 30 seconds or less. Once 95% inflated, remove the hair dryer, close the flap, insert the clear silicone plug, and screw the cap on. If your Full-Size Travelwedge needs more air, open the clear flexible valve and blow into it until firm. There is also a video on below demonstrating this. NOTE: The silicone plug is not required. You can try using the unit without it. The silicone plug just adds an additional air tight layer.
Option 3: Commercial hand or motorized pump
There are numerous hand and motorized pumps on the market. With two different valves there are many options based on what you have available.
